Features:1 Indicate the voltage value and the system will give alarm beep when voltage is low.
Data:
Operating Voltage: 4-9.6V
Alarm Voltage range：3.3V-50.4V（LIPO 1S-12S）
Weight: 2g
Wire Length：17.2mm
Setting up Alarm value：
Three Degree low voltage alarm can be set – very low, Low, and close to low voltage value.
Press button and give power to the RX board while the LED keep light.
Press the button and the one Beep means very low voltage value alarm confirmed ( alarm voltage range is 3.3V each cell )
Press the button again two Beeps means middle voltage value alarm confirmed ,(middle voltage range is 3.5V each cell)
Press the button third time three Beeps means the High voltage value alarm confirmed (the voltage range is 3.7V each cell)
Wait for 3 seconds after each step there will be One beep alarm and LED keep light, then alarm voltage value accomplished.
Reference voltage alarm algorithm
(Very low voltage: 1S：1*3.3=3.3V, 2S：2*3.3=6.6V, 3S：3*3.3=9.9V,…)
(Low voltage : 1S：1*3.5=3.5V, 2S：2*3.5=7V, 3S：3*3.5=10.5V,…)
(close to voltage： 1S：1*3.7=3.7V, 2S：2*3.7=7.4V, 3S：3*3.7=11.1V,…)
The RX board will alarm when real voltage drop to set value
Communication method between TX and RX Board：
1.Give power to the TX Board, the LED will slow flash
2.Give power to the RX Board and LED will slow flash
3.After 5 seconds the Rx board will Beep, the LED on TX Board will keep light , the LED on RX Board flash quickly it means connecting accomplished.
4. If LED on RX Board off means no signal or wrong connecting.
5. If one board power be cut, another board should be give power again.
Normal Use:
First please setting up alarm value on RX board, once set it can be stored.
Connect Testing battery to TX Board. Then connect power battery to supply power to the TX board. This is very important
There will be one Beep after giving power to RX Board, it means connecting accomplished and the system can work normally.
RX board will alarm by beep loops when the testing battery voltage drop reference value that set on setting up step.
Notes: the battery should be full charged.
Including: one TX board and one RX Board
